Vauxhall Workshop Service and Repair Manuals

 

Selector Lever Actuation Cable, Adjust     Inspect    Check adjustment of the control cable of the selector actuation. Bring selector lever consecutively in positions "P, R, N, D, 3, 2, 1" - pull knob to first or second stop. Actuating lever at transmission must engage at: "P" (foremost position, "2"), "R", "N", (1), "D", "3", "2", "1".   If actuation lever does not engage:     Remove, Disconnect    Remove battery - to do this, disconnect small relay box from bracket on battery and lay aside. Remove wiring harness plugs (3 and 4) from battery case and disconnect. If necessary: Remove reservoir for hydraulic system from battery case (2 bolts).

  Adjust   

Open lock upwards at selector actuation control cable using a small screwdriver.   Selector lever in position "P", check that selector lever engages correctly in position "P" by moving selector lever backwards and forwards without lifting pull knob.   Turn actuating lever (1) on transmission to stop (position "P", 2). Turn at front wheels until pawl in parking lock wheel of transmission engages. Press lock on selector lever actuation cable downwards and thus secure.     Install, Connect    Connect 2 wiring harness plugs and install at battery box. Install reservoir for hydraulic system (2 bolts). Install battery - fasten small relay box at bracket.