vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Component Locator > < End Shield with Main Shaft and Drive Shaft, Disassemble and Reassemble (F 13/F 15/F 17/F 18/F 18+)

 

Drive Shaft and/or Roller Bearing, Replace (F 13/F 15/F 17/F 18/F 18+)  

Illustration  

 

1  Drive shaft with gear cluster  

2  Retaining ring  

3  Ball bearing (closed)  

 

Object Number: 2390375  Size: DEFAULT

 

 

Notice: 

Transmission remains installed.  

Object Number: 616191  Size: DEFAULT  Remove, Disconnect   

Remove shift cover (1) - see operation "Shift Cover, Disassemble and Reassemble (F 13/F 15/F 17/F 18/F 18+)".  

Remove reversing lamps switch (2).  

Remove end shield cover (3) - see operation "Gasket for End Shield Cover, Replace (F 13/F 15/F 17/F 18/F 18+)".  

Remove end shield (4) from transmission - see operation "Gasket for End Shield, Replace (F 13/F 15/F 17/F 18/F 18+)".  

Object Number: 2401490  Size: DEFAULT

 

 

Object Number: 616193  Size: DEFAULT  Disassemble   

Remove drive shaft (1) with retaining ring (2) and ball bearing (3) - see operation "End Shield with Main Shaft and Drive Shaft, Disassemble and Reassemble (F 15/F 17)".  

Press off ball bearing (4) with KM-407-A (6) from drive shaft (5). With F 13 with suitable pipe - Observe installation position.  

Remove retaining ring.  

Object Number: 616201  Size: DEFAULT  Important!   

If gear cluster teeth are damaged, always check the corresponding gear on the main shaft and replace if necessary.  

Object Number: 2414091  Size: DEFAULT

 

 

Object Number: 616194  Size: DEFAULT  Assemble   

Attach new retaining ring (1) to drive shaft (2) and press on ball bearing (3) with KM-311/2 (4). For F 18/F 18+ with KM-334.  

Install drive shaft (7) with retaining ring (6) and ball bearing (5) - see operation "End Shield with Main Shaft and Drive Shaft, Disassemble and Reassemble (F 15/F 17)".  

Object Number: 2414093  Size: DEFAULT

 

 

Object Number: 616192  Size: DEFAULT  Install, Connect   

Install end shield (1) in transmission - see operation "Gasket for End Shield, Replace (F 13/F 15/F 17/F 18/F 18+)".  

Install gasket for end shield cover (2) - see operation "Gasket for End Shield Cover, Replace (F 13/F 15/F 17/F 18/F 18+)".  

Install reversing lamps switch (4) with new seal ring - tightening torque 20 Nm / 15 lbf. ft.  

Install shift cover (3) - see operation "Shift Cover, Disassemble and Reassemble (F 13/F 15/F 17/F 18/F 18+)".  

Object Number: 616196  Size: DEFAULT  Inspect   

Check transmission fluid level - see operation "Transmission Fluid Level, Check and Correct (F 13/F 15/F 17/F 18/F 18+)".  

Object Number: 2401489  Size: DEFAULT

 

 


Related Literature Units
-
-
-
-
-

Component Locator > < End Shield with Main Shaft and Drive Shaft, Disassemble and Reassemble (F 13/F 15/F 17/F 18/F 18+)