Fuel Lines on Bulkhead, Remove and Install (X 25 XE, Y 26 SE)
Remove, Disconnect
Remove front axle body - see operation "Front Axle Body, Remove and Install" in group "E".
Notice:
Hydraulic lines for power steering must not be disconnected.
Detach union nuts (1) from fuel hoses on distributor pipe and unclip from brackets on bulkhead.
Disconnect wiring harness (3) from bulkhead.
Identify fuel lines and remove using KM-796. Close off fuel lines with Plugs KM-807.
Unbolt two brackets (4) at vehicle floor.
Remove fuel lines from below - note line layout.
Install, Connect
Insert fuel lines free of tension from below and fasten on vehicle floor using brackets (2 and 4).
Remove KM-807 and allow fuel lines to engage audibly.
Fasten wiring harness to bulkhead.
Fasten fuel hoses to distributor pipe.
Install front axle body - see operation "Front Axle Body, Remove and Install" in group "E".
Tighten (Torque)
Fuel hoses to distributor pipe - 15 Nm / 11 lbf. ft.
Remove, Disconnect 
Install, Connect 
Tighten (Torque)