Wiring Harness - Tailgate, Remove and Install Model F68
 Remove, Disconnect Remove tailgate inner panelling - see operation "Tailgate Inner Panelling, Remove and Install, Model F68" in group "C". Remove inner panelling for rear quarter panel - see operation "Inner Panelling - Rear Quarter Panel, Remove and Install, Model F19" in group "C". Release and detach wiring harness plug (5). Remove cable tie (6), disconnect wiring harness plug (3), disconnect wiring harness plug for centre brake lamp (1), unbolt ground (2). Disconnect wiring harness plug for heated rear screen (4), proceed analogously for right side. | 
|
 Install, Connect Draw wiring harness into tailgate, route and secure in position with cable ties. Connect wiring harness plug to wiper motor, centre brake lamp, central locking servo motor and connections for heated rear screen- right and left, bolt on ground cable. Draw wiring harness in passenger compartment, fasten with cable ties and connect to body wiring harness. Bolt ground cable to rear end panel. Install anti-kink protection and panelling.
|
