volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 7680 > < Diagram Information and Instructions|Page 7678
Page 4
background image

If the power supply to the Door Control Module is lost, the one-touch function will be deactivated. To reset the one-touch function, run the window all
the way down, then up completely. The Control Module will lock the sensor input position into memory, and the one-touch function will be restored.

The power windows remain functional for 10 minutes after the ignition is switched off, provided that a door is not opened.  The one-touch up function
is deactivated when the ignition is switched off.

Interior Light Control

The Central Control Module for Comfort System -J393- controls the switching and dimming of the interior lights. It also limits the length of time the
lights remain on if the doors are left open with the ignition switched off.

The Central Control Module for Comfort System -J393- receives signals from the Door Contact Switches and the Rear Lid Contact Switch. They are
microswitches built into the lock assemblies.

If the interior light has been switched on, the control module will switch it off again after one hour. If the light is switched off, then on again, the
sequence repeats.

Interior lights will be switched on for a maximum of 30 seconds, then dimmed to off, if the control module receives any of the following inputs:
-

Car unlocked with key or remote control.

-

One door opened from inside.

-

Ignition key removed from ignition with doors closed.

When the doors are locked, or when a door is closed after the doors have been locked, the interior lights are switched off.

If an accident deploys an airbag, the Airbag Control Module -J234- sends a signal to the Central Control Module for Comfort System -J393-.

-

The interior lights are switched on for 10 minutes (if the light switches are set to door contact position).

-

The doors are unlocked.

-

The emergency flashers are activated.

Rear lid and fuel tank lid locks

The Rear Lid is always mechanically locked. It can be opened electrically using the switch in the driver's door, or the remote transmitter. In the event
of an electrical system malfunction, it can be opened using the key.

The trunk release switch, located in the driver's door panel, signals the Central Control Module for Comfort System -J393-. The relay supplies current
to the motor to unlock the rear lid.

Diagram Information and Instructions|Page 7680 > < Diagram Information and Instructions|Page 7678