Beetle L4-2.0L (AEG) (2000)
-
Check wiring for open circuit between Test Box and 4-pin harness connector using Wiring diagram.
-
Terminal 2 + socket 28, resistance 1.5 Ohms maximum
If specification obtained
-
Check wiring from terminal 1 to fuel pump relay J17 using Wiring diagram.
-
Display the Readiness code. Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Displaying Readiness Code", See: Computers and
Control Systems/Testing and Inspection
-
If DTC memory was erased or if the ECM was disconnected from Battery + , set the Readiness code. Refer to "Monitors, Trips and/or Drive Cycle
(Readiness Codes)/Setting Readiness Code", See: Computers and Control Systems/Testing and Inspection
If wiring OK:
-
Replace Engine Control Module.