Cabrio GLX L4-2.0L (ABA) (2001)
^
Pressing out and in
10. Circlip
Wheel Speed Sensor For Front Axle, Removing And Installing
Removing
-
Raise vehicle.
-
Disconnect wheel speed sensor wiring connector -1-.
-
Remove bolt -2- from wheel bearing housing.
-
Remove wheel speed sensor from wheel bearing housing.
Installing
-
Before inserting speed sensor, clean mounting hole inner surface and coat sensor with lubricant G 000 650.
-
Insert speed sensor into mounting hole in wheel bearing housing and tighten bolt to 8 Nm (70 inch lbs.).
-
Connect wheel speed sensor wiring connector.
-
Turn wheels fully to left and right lock and check clearance of speed sensor wiring.
Front Wheel Speed Sensor Wiring, Removing And Installing
Required Special Tools And Equipment
^
VAS 1978 wiring repair set
Removing
-
Obtain radio code on vehicles with coded radio.
-
Disconnect battery.
-
Remove Mass Air Flow (MAF) sensor connector -1- from air filter duct.
-
Remove bolts -2- at air filter -3- and place filter to left side.