Cabrio GLX L4-2.0L (ABA) (2001)
/Page-1048002.png)
2. Manual selector valve control Adjusting.
3. Selector shaft with selector segment
^
Removing and installing refer to Fig. 2
4. Spring pin
^
Driving out and in refer to Fig. 1
5. Engaging lever Insert together with selector shaft and detent segment
6. Detent segment Insert together with selector shaft and engaging lever
7. Lock washer
8. Bolt
^
10 Nm (89 inch lbs.)
9. Spring for selector segment
10. Bolt
^
10 Nm (89 inch lbs.)
11. O-ring
^
Always replace
^
Only install on shafts with groove for circlip
12. Washer
13. Shaft for detent lever is secured by circlip and bearing cap of drive pinion
14. Return spring
^
Inserting refer to Fig. 4
15. Detent lover
^
Inserting with return spring refer to Fig. 4
16. Parking lock gear
^
Rounded side faces drive pinion teeth
17. Bolt
^
14 Nm (1O ft. lbs.)
18. Supporting plate
^
Installing refer to Fig. 3
19. Guide plate
^
Insert before supporting plate Fig. 3
20. Transmission housing
^
It is not necessary to remove drive gear to disassemble parking lock
21. O-ring
^
Always replace
22. Multi-function Transmission
^
Range Switch 4125-
^
Insert so that 1 pin each is resting on a slope of detent segment
^
Test in vehicle with 0n Board Diagnosis (OBD).
23. Retainer
^
For multi-function switch
24. Bolt
^
10 Nm (89 inch lbs.)
25. Mount bushing
^
Removing refer to Fig. 5
^
Installing refer to Fig. 6
26. O-ring
^
Always replace
27. Vehicle Speed Sensor (VSS) -G68- Test in vehicle with On Board Diagnosis (OBD)
28. Bolt
^
10 Nm (89 inch lbs.)
29. O-ring
^
Always replace
30. Transmission Vehicle Speed Sensor (VSS) -G38- Test in vehicle with On Board Diagnosis (OBD)
31. Bolt 10 Nm (89 inch lbs.)
32. Retainer
^
For wire to Vehicle Speed Sensor (VSS)
^
Secure with bolt -item 31 -
33. Retaining clip
^
For wire to Vehicle Speed Sensor (VSS)
34. Lever
^
For selector shaft
35. Bolt
^
10 Nm (89 inch lbs.)
36. O-ring
^
Pry out with screwdriver
^
Drive in flush with VW 423
