Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-2035001.png)
Pressure Plate: Procedures
Self-adjusting pressure plate adjusting ring, check and reset if necessary only on new clutches made by "LuK". 02Q, 6 Speed M/T
Special tools, testers and auxiliary items required
^
Punch VW 412
^
Thrust pad 3062
^
The following step applies to clutches made by "LuK"
^
Installation of a new pressure plate and new clutch disc is required.
^
If previous pressure plate and clutch plate are re-installed, adjusting ring should not be reset.
^
On clutches made by "Sachs", pressure plate cannot be reset.
If you install a new pressure plate and clutch disc, check position of adjusting ring in pressure plate.
^
Adjusting ring must be reset to stop
^
Springs - arrow - are then pressed together on "block"
Otherwise, clutch contact pressure is reduced and this causes increased clutch plate wear.
If springs are not pressed together on "block", adjusting ring must be reset.
-
Insert 3 bolts, M6 x 35 - A - offset by 120° (as shown in illustration) into holes in pressure plate.
