Eos (1F7) V6-3.2L (BUB) (2008)
Convertible Top Position Sensor / Switch: Service and Repair
Rear Window Frame Lock Sensors
Rear Window Frame Lock Sensors
-
Open the roof with the convertible top switch until it is just before the position shown.
-
Place (VAS 6365) in lowest position - 2 -.
-
Place the (VAS 6365) in the mounting hole in the main hinge - 1 - and rotate the base - 4 - so that it is not positioned in the opening in the
longitudinal.
-
Open bypass screw on hydraulic pump, this depressurizes the hydraulic system.
-
Place supports in center position - 2 -.
-
Secure supports on rear window frame locking mechanism - 1 -.
-
Lower rear window frame until supports - 4 - are positioned on longitudinal member - 5 -.
‹› All screws are microencapsulated and must always be replaced.
‹› Sensor consists of 2 parts, magnet is secured on locking hooks in main hinge.