Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-2220003.png)
-
Place base - 2 - of (VAS 6367) on seat belt guide rail - 1 - - arrow a -.
-
Press the support together and allow the rectangular formation on the head - 3 - on the head to position itself on the guide rear guide rail - 4 -
through the force of the spring- arrow b -.
-
Tighten screws - 5 -.
-
Measure the dimension between the head - 3 - and the screw - 5 - and note it down.
-
Remove the support again.
‹› When the luggage compartment trim is installed, make sure the support is not positioned in the opening on the longitudinal member.
‹› To support roof, both sides of luggage compartment trim should be either removed or installed.
‹› The bypass screw on the hydraulic pump must be opened after the repair position has been reached on vehicle from May 07. This prevents
damaging the hydraulic system.
