Eos (1F7) V6-3.2L (BUB) (2008)
‹› Brake line must contact stop when screws are tightened, otherwise the flared head will not be formed correctly.
-
Clamp the brake line in the flanging tool until it cannot be moved any more. Fold the stop - A - up and tighten the screws diagonally with the angle
screwdriver - C -.
-
Turn the spindle to the stop in the flanging tool.
-
Turn the spindle back.
-
Loosen the screws diagonally.
-
Remove the brake line from the flanging tool, clean and check the brake line and flared head.
Briefly rinse the part of the brake line remaining in vehicle.
-
Connect the brake charger/bleeder unit (VAS 5234 ), place the bleeder container hose on the flanged head of the brake line and run the brake
charger/bleeder unit (VAS 5234) briefly until some brake fluid runs through.
-
Blow out the brake line to be inserted with compressed air.
-
Join the brake lines with a connecting piece - E -.