Eos (1F7) V6-3.2L (BUB) (2008)
Removing
-
Remove wheel.
-
Remove wheel housing liner.
-
Remove coil spring. Refer to => [ Coil Spring ] See: Suspension Spring ( Coil / Leaf )/Service and Repair/Removal and Replacement/Coil Spring.
-
Remove bolts - arrows -.
-
Remove bolt - arrow -.
-
Remove shock absorber.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› The bolted connections of the shock absorber to the wheel bearing housing must only be fastened when the dimension "a" is achieved! Refer to =>
[ Measure Dimension ] See: Service and Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
-
Insert shock absorber and tighten bolts - arrows -.