Eos (1F7) V6-3.2L (BUB) (2008)
-
Lightly oil NEW seal on outer circumference.
-
Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128).
-
Drive in NEW seal until seated using tube (VW 423); be sure not to distort seal.
-
Install lever and nut, tighten to 20 Nm.
Lever of selector shaft fits on to splines only in one position.
-
Attach the selector lever cable to the transmission. Refer to => [ Selector Lever Cable ] See: Selector Lever Cable.
-
Adjust the selector lever cable. Refer to => [ Selector Lever Cable, Adjusting ] See: Adjustments.
Selector Lever Cable
Selector Lever Cable
‹› After installation, cable must be checked for ease of movement and must be adjusted.
Removing
-
Place selector lever in the "S" position.
Loosen adjustment bolt - arrow -.