Eurovan V6-2.8L (AXK) (2001)
/Page-1188003.png)
^
Ejecting and pressing in go to Fig. 3
8 - Threaded bore in subframe
9 - Right tie rod, 70 Nm
^
unbolt and bolt in Fig. 1
10 - Cable ties
11 - Boot
^
Check boot for damage
^
Boot Can be replaced with steering gear installed
^
Must not be twisted after toe IS adjusted
12 - Left tie rod, 70 Nm
^
unbolt and bolt in go to Fig. 1
13 - Hexnut, tighten to 55 Nm.
14 - Tie rod end
^
Check dust caps for damage and proper seating
^
Press off go to Fig. 2
15 - Hex bolt, self locking, 65 Nm
^
Always replace
16 - Control line
^
14 Nm
^
Make sure O-ring is not damage during installation, make sure installation is free of stress
^
Do not damage surface, if necessary repair paint damage
^
Can be removed and installed with the power steering gear installed
17 - Sealing ring
^
Always replace
18 - Power steering gear
19 - Hex bolt
20 - Lower
^
intermediate steering shaft with universal joint
Fig. 1 unbolt and bolt in tie rod
a - VAG1332/5 open-end spanner
b - VAG1332 torque wrench
Note: Do not use locking fluid.
