Golf Mk4
| Overview - “K1” components |
| 1 - | Clutch housing |
| 2 - | Piston |
| q | On the piston, there are two O-rings which must not be damaged. |
| 3 - | Spring |
| 4 - | Piston cap |
| 5 - | Retaining ring |
| q | For piston. |
| 6 - | Dished spring |
| q | “Convex” side faces piston cap. |
| 7 - | Outer plate |
| q | Figure shows 7 plates. Depending on gearbox, fewer may be installed. |
| 8 - | Inner plate |
| q | Figure shows 7 plates. Depending on gearbox, fewer may be installed. |
| 9 - | Last outer plate “pressure plate” |
| q | Thicker than the other outer plates. |
| 10 - | Retaining ring |
| q | For plates. |
| q | Ring will not be renewed. Therefore, remove and install carefully, being careful not to over-stretch it. |
