Workshop Manuals Factory service & repair Volkswagen
01 Running gear02 Body03 Engine04 Vehicle electrics05 Power transmission06 Heating, ventilation, air conditioning07 Power unit08 Heating, ventilation, air conditioning system
Volkswagen Golf Mk405 · Power transmission
05 · Transmission

Servicing clutch

Make
Volkswagen
Model
Golf Mk4
Section
5-speed manual gearbox 02J › Clutch, control › Servicing clutch
Power transmissionServicing clutch
Servicing clutch
Servicing clutch
 
W30-0007

Special tools, workshop equipment, test and measuring appliances and auxiliary items required

  • ◆ 3067 Counter-hold
  • ◆ 3190 A Centralizing mandrel
  • ◆ V.A.G 1331 Torque wrench
 
N30-0147

Notes:

  • ◆ Before replacing the clutch and pressure plate note fault finding transmission No.9 - Defects on the clutch and clutch mechanism
  • ◆ Replace clutch plates and pressure plates with damaged or loose rivets
  • ◆ Select correct clutch plate and pressure plate according to parts list and engine code.
  • Flywheel
    • ◆ Ensure centring pins are a tight fit
    • ◆ Contact surface for clutch lining must be free of grooves, oil and grease
    • ◆ Removing and installing

=> Repair group13; Removing and installing sealing flange and flywheel/drive plate

 
N30-0147
  • Clutch plate
    • ◆ Diameter
      =>Page 00-3
    • ◆ Installation position on two-part flywheel: Shorter hub end (arrow) points towards pressure plate
    • ◆ Installation position with single piece flywheel: spring cage faces the pressure plate
    • ◆ Centring => Fig.1
    • ◆ Lightly grease splines

Note:

Clean input shaft splines and on used clutch plates, the hub splines, remove corrosion and apply only a very thin coating of grease Part No: G 000 100 to the input shaft splines. Then move clutch plate to and fro on input shaft until hub moves freely on shaft. Excess grease must be removed.

 
N30-0147
  • Pressure plate
    • ◆ Removing and installing => Fig.1
    • ◆ Check ends of diaphragm spring
      => Fig.2

Note:

Pressure plates are protected against corrosion and greased. Only the contact surface may be cleaned, otherwise the service life of the clutch will be considerably reduced.

  • Bolt
    • ◆ Allocate using parts catalogue
    • ◆ On two-part flywheel
    • ● M6 thread = 13 Nm
    • ● M7 thread = 20 Nm
    • ◆ On single piece flywheel
    • ● 20 Nm
    • ◆ Loosen and tighten gradually and diagonally
 
V30-0378

→ Fig.1     Centring clutch plate and removing and installing pressure plate

  • ‒ Loosen and tighten bolts gradually and diagonally.
  • ‒ Reverse position of retainer 3067 when removing.

Note:

Pressure plate contact surface and clutch plate must make full contact with flywheel. Tighten bolts diagonally and evenly to prevent damage to the centring holes in the pressure plate housing and the centring pins in the flywheel.

 
V30-0094

→ Fig.2     Checking ends of the diaphragm spring

  • ● Wear up to half the thickness of the diaphragm spring is permitted.

Parts & tools for this job For Volkswagen Golf

As an Amazon Associate we earn from qualifying purchases.