A - Assembling sealing flange with sender wheel on assembly toolT10017
A - Assembling sealing flange with sender wheel on assembly toolT10017
A - Assembling sealing flange with sender wheel on assembly tool -T10017-
–
Screw hexagon nut -A- to shortly before the clamping surface (ground section) -B- on the threaded spindle.
–
Clamp assembly tool -T10017- in a vice on clamping surface -B- of threaded spindle.
–
Press assembly housing -C- downwards until it lies on hexagon nut -A--arrow-.
Note
Inner part of assembly tool and assembly housing must be at same height.
–
Remove securing clip -A- from new sealing flange.
Note
The sender wheel must not be taken out of the sealing flange or twisted.
The locating hole -B- on the sender wheel -C- must align with the marking -A- on the sealing flange.
–
Place sealing flange with front side downwards on a clean flat surface.
–
Push sealing lip support ring -A- downwards in direction of arrow until it lies on flat surface.
Upper edge of sender wheel and front edge of sealing flange must align -arrows-.
–
Place the sealing flange, with the forward side on the assembly tool -T10017-, so that the locating pin -A- can be inserted in the sender wheel hole -B-.
Note
Ensure sealing flange lies flat on assembly tool.
–
Push support ring for sealing lip -B- against surface of assembly device -T10017- whilst tightening the three knurled screws -A- so that locating pin cannot slide out of sender wheel hole.
Note
When installing sealing flange, ensure that sender wheel remains fixed in the assembly tool -T10017-.