volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting panel seal > < Zero position

Golf Mk5

Adjusting height of glass panel of sliding/tilting sunroof
Adjusting height of glass panel of sliding/tilting sunroof
  Note
The glass panel height adjustment is performed after the glass panel has been closed from slide open position.
Sliding/tilting sunroof glass panel 0 position OK.
   
–  Remove bellows: → Chapter
–  Remove sliding/tilting sunroof glass panel -2- securing bolts -1-.
–  Run sliding/tilting sunroof glass panel to “open” position.
–  Run sliding/tilting sunroof glass panel to “closed” position.
–  Carry out height adjustment of sliding/tilting sunroof glass panel at front and rear on both sides as follows:
  N60-10027
Panel adjustment front:
-a- = 0…1 mm lower than roof
-Arrow- = Forwards
–  Tighten front screws (5 Nm).
  N60-0098
Panel adjustment rear:
-b- = 0…1 mm higher than roof
-Arrow- = Forwards
–  First tighten middle and then rear screws (5 Nm).
  Note
t  To achieve the best possible optical appearance, ensure that the adjustment on left and right are as far as is possible uniform (symmetric).
t  The glass panel should not be higher than the roof at any point at the front or lower than the roof at any point at the rear.
–  Install bellows → Chapter.
  N60-0099

Adjusting panel seal > < Zero position