| Procedure after an accident when belt tensioner and/or airbag was triggered |
| t
| Basic settings of seat occupied recognition control unit -J706- must be performed after each triggering of front passenger airbag and/or seat belt tensioner on front passenger side. Perform basic settings using a vehicle diagnosis tester in „Guided fault finding“ mode. |
| t
| When a seat rail and/or seat pan require replacing, due to deformation, after an accident then the seat recognition must also be replaced using a „seat recognition repair kit“. Finally carry out basic settings of seat occupied recognition control unit -J706-. Perform basic settings using a vehicle diagnosis tester in „Guided fault finding“ mode. |
|
|
|
