volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing clutch position senderG476

Golf Mk5

Removing
Removing
LHD
–  First check whether a coded radio is fitted. If so, obtain anti-theft code.
–  Remove battery and, if necessary, detach backwall of battery box → Electrical system; Rep. gr.27.
Right-hand drive
An insulation mat is installed in conjunction with some engines. Appearance may be different from that illustrated.
   
–  Remove heat shield from pipe/hose line -arrows-.
Continuation for all
  N34-11205
If a pipe/hose line or plastic line -1- with a round component is installed directly beneath the master cylinder, the pipe/hose line or plastic line must be removed.
  Note
t  During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly.
t  Place a lint-free cloth under the master cylinder.
  N30-10122
–  Clamp off supply hose to master cylinder using hose clamp -3094-.
  A30-0127
–  Release securing clip -2- with a screwdriver or a pointed object and pull out of master cylinder to stop.
–  Pull pipe/hose line or plastic line -1- out from master cylinder and seal hose.
–  Disconnect electrical connector -4-.
–  Unclip clutch position sender -G476- from master cylinder -arrow- and remove.
  N30-10122

Installing > < Removing and installing clutch position senderG476