Golf Mk5
| Assembly overview - crankcase |
| 1 - | Cylinder block |
| q | Removing and installing sealing flange and flywheel → Chapter. |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrods → Chapter. |
| 2 - | Bracket |
| q | For charge air pipe. |
| 3 - | 10 Nm |
| 4 - | Gasket |
| q | Renew |
| 5 - | Oil filter bracket |
| q | Assembly overview → Chapter |
| 6 - | 15 Nm + 1/4 turn (90 °) further |
| q | Renew |
| q | First fit upper left and lower right bolts and then tighten all four bolts diagonally. |
| 7 - | Bracket |
| 8 - | 20 Nm |
| 9 - | Connection |
| q | For thermostat |
| 10 - | 15 Nm |
| 11 - | O-ring |
| q | Renew |
| 12 - | Thermostat |
| q | Removing and installing → Chapter. |
| q | Note installation position → Chapter. |
| q | Checking: heat up thermostat in water. |
| q | Opening begins at approx. 85 °C. |
| q | Ends at approx. 105 °C. |
| q | Opening lift min. 7 mm. |
| 13 - | Hexagon bolt |
| q | Tightening sequence and torque specifications → Heating, air conditioning; Rep. Gr.87. |
| 14 - | Bracket |
| q | For alternator and, if fitted, air conditioner compressor. |
| 15 - | Tensioning device for poly V-belt |
| 16 - | 25 Nm |
| 17 - | Sump |
| q | Clean sealing surface before fitting. |
| q | Install with silicone sealant -D 176 404 A2- → Chapter. |
| 18 - | 15 Nm |
