Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | 4-cylinder injection engine (2.0 l engine, direct injection) | Enginecrankshaft group, pistons | Cylinder block attachments, engine codes BLX, BLY, BLR, BVX, BVY, BVZ

Removing and installing poly V-belt

Special tools and workshop equipment required

t	Locking pin -T10060 A-

Removing poly V-belt:

–	Remove noise insulation → General body repairs, exterior; Rep. Gr.50.

–	Mark direction of rotation of poly V-belt.

–	Swivel tensioning device in -direction of arrow- to relieve tension on poly V-belt.

–	Lock tensioning element using locking pin -T10060 A-.

–	Remove poly V-belt.

Installing poly V-belt

Installation is carried out in the reverse order. When installing, note the following:

–	When fitting poly V-belt, check direction of belt rotation and proper seating of belt in belt pulleys.

–	Fit poly V-belt for air conditioner compressor last.

After completing repairs always:

–	Start engine and check belt running.

Volkswagen Workshop Service and Repair Manuals