Golf Mk5
| Assembly overview - exhaust system, engine codes AXW, BLX |
| 1 - | 25 Nm |
| q | Renew |
| q | Coat studs of exhaust manifold with high-temperature paste |
| 2 - | Lambda probe after catalytic converter -G130- |
| q | 55 Nm |
| q | Bank 1, probe 2 |
| q | Colour of connector: black. |
| q | Grease only the threads with high-temperature paste. The paste must not penetrate into the slots on the probe body |
| 3 - | Lambda probe 2 after catalytic converter -G131- |
| q | 55 Nm |
| q | Bank 2, probe 2 |
| q | Grease only the threads with high-temperature paste. The paste must not penetrate into the slots on the probe body |
| q | Colour of connector: brown. |
| 4 - | Exhaust gas temperature sender 1 -G235- |
| q | Specified torque: 45 Nm |
| q | Grease thread with high-temperature paste. |
| 5 - | NOx storage catalytic converter |
| q | With front exhaust pipe. |
| q | Protect from damage by knocks and impact. |
| q | With flexible connection (de-coupling element). |
| q | Do not bend flexible connection more than 10° - otherwise it can be damaged. |
| q | Removing and installing → Chapter |
| q | Aligning exhaust system free of stress → Chapter |
| 6 - | NOx sender -G295- |
| q | Specified torque: 60 Nm |
| q | Grease only the threads with high-temperature paste. The paste must not penetrate into the slots on the probe body |
| 7 - | Rubber mounting |
| q | Renew if damaged. |
| 8 - | Threaded union |
| q | Tighten bolted connections evenly. Specified torque and installation position → Chapter |
| 9 - | Rubber mounting |
| q | Renew if damaged. |
| 10 - | Rear silencer |
| q | In initial equipment, component with centre silencer. Can be renewed individually for repair purposes |
| q | Aligning exhaust system free of stress → Chapter. |
| q | Separate exhaust system → Chapter. |
| 11 - | Mounting |
| q | Renew if damaged. |
| 12 - | 25 Nm |
| 13 - | Rear clamp |
| q | For separate replacement of centre and rear silencers |
| q | Tighten bolted connections evenly. Specified torque and installation position → Chapter |
| 14 - | Centre silencer |
| q | Combined in one unit with rear silencer as original equipment. Can be renewed individually for repair purposes |
| q | Aligning exhaust system free of stress → Chapter. |
| q | Separate exhaust system → Chapter. |
| 15 - | Rubber mounting |
| q | Renew if damaged. |
| 16 - | 25 Nm |
| 17 - | Front clamp |
| q | Align exhaust system free of stress before tightening clamp → Chapter. |
| q | Tighten bolted connections evenly. Specified torque and installation position → Chapter |
| 18 - | Threaded union |
| q | Tighten bolted connections evenly. Specified torque and installation position → Chapter |
| 19 - | Mounting |
| 20 - | 25 Nm |
| 21 - | Mounting |
| q | Renew if damaged. |
| 22 - | Gasket |
| q | Renew |
