Golf Mk5
| Assembly overview - sealing flange |
| 1 - | 100 Nm + 1/2 turn (180°) further. |
| q | Renew. |
| q | Removing and installing → Chapter |
| 2 - | Vibration damper |
| q | Removing and installing → Chapter |
| 3 - | 10 Nm |
| 4 - | Sealing flange |
| q | Coat sealing surfaces with sealant -D 176 501 A1-. |
| q | With seal. |
| q | Renewing → Chapter |
| 5 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 6 - | Sealing flange |
| q | Coat sealing surfaces with sealant -D 176 501 A1-. |
| 7 - | Seal |
| q | Remove using extractor hook -T20143/2-. |
| q | PTFE-type oil seal |
| Identification: Without inner coil spring. |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| q | Removing and installing → Chapter |
| 8 - | Intermediate plate |
| 9 - | Dual-mass flywheel |
| q | Removing and installing → Chapter |
| 10 - | 60 Nm + 1/4 turn (90°) further |
| q | Renew. |
| q | To loosen and tighten, use counterhold -T10044- (with 5 mm spacers) or counterhold -T10069-. |
| 11 - | 25 Nm |
