Golf Mk5
| Assembly overview - exhaust manifold, front exhaust pipe with catalytic converters |
| 1 - | Connector |
| q | Black, 6-pin. |
| 2 - | Lambda probe -G39-, 50 Nm |
| q | Bank 1, probe 1 |
| q | Installed in exhaust gas stream of cylinders 1, 2 and 3 |
| q | Grease only the threads with high-temperature paste. The paste must not penetrate into the slots on the probe body |
| q | Removing and installing → Chapter. |
| 3 - | Lambda probe 2 -G108-, 50 Nm |
| q | Bank 2, probe 1 |
| q | Installed in exhaust gas stream of cylinders 4, 5 and 6 |
| q | Grease only the threads with high-temperature paste. The paste must not penetrate into the slots on the probe body |
| q | Removing and installing → Chapter. |
| 4 - | Connector |
| q | Brown, 6-pin |
| 5 - | 40 Nm |
| q | Renew. |
| 6 - | Lambda probe 2 after catalytic converter -G131-, 50 Nm |
| q | Bank 2, probe 2 |
| q | Installed in exhaust gas stream of cylinders 4, 5 and 6 |
| q | Grease only the threads with high-temperature paste. The paste must not penetrate into the slots on the probe body |
| q | Remove and install with Lambda probe open ring spanner set -3337-. |
| 7 - | Connector |
| q | Brown, 4-pin |
| 8 - | Lambda probe after catalytic converter -G130-, 50 Nm |
| q | Bank 1, probe 2 |
| q | Installed in exhaust gas stream of cylinders 1, 2 and 3 |
| q | Grease only the threads with high-temperature paste. The paste must not penetrate into the slots on the probe body |
| q | Remove and install with Lambda probe open ring spanner set -3337-. |
| 9 - | Connector |
| q | Black, 4-pin. |
| 10 - | Heat shield |
| 11 - | Intake manifold support |
| 12 - | 20 Nm |
| 13 - | Seal |
| q | Renew. |
| 14 - | 25 Nm |
| 15 - | Exhaust manifold |
| 16 - | 25 Nm |
| q | Renew. |
| 17 - | Front silencer |
| q | Not installed |
| 18 - | To centre silencer |
| 19 - | 25 Nm |
| 20 - | Mounting |
| q | For front exhaust pipe, left and right |
| 21 - | Catalytic converter |
| q | Installed in exhaust gas stream of cylinders 1, 2, 3 right and 4, 5 and 6 left |
| 22 - | Front exhaust pipe |
| q | With decoupling element. |
| q | The flexible joint must not be bent by more than 20° during removal - risk of damage. |
| q | Removing and installing front exhaust pipes with catalytic converters and front silencers → Chapter |
