Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | Fuel supply system - Petrol engines | Fuel supply, gas operation | Activated charcoal filter system | Removing and installing activated charcoal filter | Removing and installing activated charcoal filter (engine codes CBTA, CBUA, BGP, BGQ)

Removing and installing activated charcoal filter (engine codes CBTA, CBUA, BGP, BGQ)

Special tools and workshop equipment required

t	Engine and gearbox jack -V.A.G 1383 A-

Removing:

–	Remove centre and rear silencers.

–	Remove heat shield -arrows-.

–	Position engine and gearbox jack -V.A.G 1383 A- below rear axle to support.

–	Loosen securing bolts of rear axle -arrows- and unscrew approx. 20 mm.

–	Lower rear axle slowly using engine and gearbox jack -V.A.G 1383 A-.

–	Pull off breather lines -A- by pressing release tab.

–	Unscrew bolts -B-.

–	Release retaining tab -A- using a screwdriver. Turn activated charcoal filter approx. 90° to right -B- and remove activated charcoal filter.

Installing:

Installation is carried out in the reverse order. When installing, note the following:

–	Fit breather lines so that they engage audibly.

–	Install rear axle → Running gear; Rep. gr.42.

Specified torque

Component	Nm
Activated charcoal filter to body	8

Volkswagen Workshop Service and Repair Manuals