volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Fault display via warning lamps > < ABS Mark 70 (ABS/TCS)
ABS Mark 60 EC (ABS/EDL/TCS/ESP)
   
ABS Mark 60 EC (ABS/EDL/TCS/ESP)
1 - ABS control unit -J104-
q   Location: on the hydraulic unit on right in engine compartment.
q   Do not separate connector before successfully completing self-diagnosis. Switch ignition off before separating connector.
The following components are integrated into the control unit:
t  Lateral acceleration sender -G200-
t  Yaw rate sender -G202-
t  Longitudinal acceleration sender -G251- (depending on equipment fitted)
q   Removing and installing → Chapter.
2 - ABS hydraulic unit -N55-
q   Location: on right in engine compartment.
The hydraulic unit consists of the components:
t  ABS hydraulic pump -V64-
t  Brake pressure sender -G201-
t  Valve block (contains inlet and outlet valves).
q   ABS hydraulic pump -V64- and valve block must not be separated from one another.
q   Removing and installing → Chapter.
3 - Brake pad warning lamp -K32-
q   Location: in dash panel insert.
q   Function: → Chapter.
4 - ABS warning lamp -K47-
q   Location: in dash panel insert.
q   Function: → Chapter.
5 - ESP and TCS warning lamp -K155-
q   Only vehicles with ABS/EDL/TCS/ESP.
q   Location: in dash panel insert.
q   Function: → Chapter.
6 - Brake system warning lamp -K118-
q   Location: in dash panel insert.
q   Function: → Chapter.
7 - Brake light switch -F-
q   Including brake pedal switch -F47-.
q   Location: on brake master cylinder.
q   Removing and installing → Chapter.
8 - TCS and ESP button -E256-
q   Only vehicles with ABS/EDL/TCS/ESP.
q   Location: in centre console
9 - Diagnostic connection
q   Location: Driver footwell cover.
10 - Steering angle sender -G85-
  Note
In vehicles equipped with 3rd generation electromechanical power steering, the steering angle sender is located in the steering box.
q   Location: in steering box.
q   Removing and installing → Chapter.
11 - Front right/left speed sensor -G45-/-G47-
q   Removing and installing → Chapter.
12 - Wheel bearing unit
q   ABS sensor ring is installed in wheel bearing.
13 - Rear right/left speed sensor -G44-/-G46-
q   Removing and installing (front-wheel drive) → Chapter
14 - Wheel hub with wheel bearing
q   ABS sensor ring is installed in wheel bearing.

   

Fault display via warning lamps > < ABS Mark 70 (ABS/TCS)