volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Connecting auxiliary heater Thermo Top V to coolant circuit > < Removing and installing heater coolant shut-off valveN279

Golf Mk6

Bleeding coolant circuit
Bleeding coolant circuit
  Note
t  Because the heater coolant shut-off valve -N279- (optional) will be actuated depending on the coolant temperature and only with the auxiliary heater switched on, the auxiliary heater must be switched on during the bleeding procedure.
t  Air in the coolant circuit or the auxiliary heater can cause the auxiliary heater to overheat. The fault „control unit defective“ will be stored in the auxiliary heater. If this fault occurs several times in a row, the auxiliary heater will be blocked electronically. This blockage can be removed using the vehicle diagnosis, testing and information system -VAS 5051B- or a later model. Start the function „adaptation“ in the vehicle diagnosis, testing and information system -VAS 5051B-.
–  Fill coolant circuit → Rep. gr.19.
–  Switch on engine and then auxiliary heater. Press, for example, the instant heating button -E537--1-.
   
Heating / Climatic Golf  ► 2008:
  N82-10102
Climatronic Golf  ► 2008:
  N82-10104
Climatic Golf  ► 2009:
  N82-10381
Climatronic Golf 2009 ►:
–  Set temperature on operating unit (heating, Climatic or Climatronic) to highest stage and open dash panel vents.
–  Run engine at idling speed for 3 minutes and then at a higher speed, about 2,300 rpm, for 3 minutes longer.
–  Switch off auxiliary heater using instant heating button -E537--1-.
–  Turn off engine.
–  Check coolant lever in coolant reservoir and top up if necessary → Rep. gr.19.
  N82-10382

Connecting auxiliary heater Thermo Top V to coolant circuit > < Removing and installing heater coolant shut-off valveN279