Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Power unit | 4-cyl. direct injection engine (2.0 l 4V turbocharger, toothed belt drive) | Enginecrankshaft group, pistons | Cylinder block, gearbox end

Removing and installing flywheel

Special tools and workshop equipment required

t	Counterhold 3067

Removing

Caution

Dual-mass flywheel may be destroyed on unscrewing bolts -B- with a pneumatic nutrunner or impact wrench.

Dual-mass flywheel may be destroyed.

Only unscrew dual-mass flywheel bolts by hand.

Carry out the following work:

–	Rotate dual-mass flywheel -A- so that bolts -B- align centrally with the holes -arrows-.

–	When removing bolts -B-, make sure that screw heads do not jam on flywheel.

–	Insert counterhold -3067- in hole on cylinder block.

–	Mark position of flywheel in relation to engine.

–	Unscrew flywheel.

Installing

Install in reverse order. In the process, note the following:

–	Renew bolts.

Specified torque

Component		Nm
Dual-mass flywheel to crankshaft		60 + 90°¹⁾

¹⁾ 90° equals a quarter of a turn

Volkswagen Workshop Service and Repair Manuals