Golf Mk6
| Assembly overview - intake manifold |
| 1 - | 10 Nm |
| 2 - | Retaining clamp |
| 3 - | 3 Nm |
| 4 - | Stud, 10 Nm |
| 5 - | Gasket |
| q | Renew. |
| 6 - | Intake manifold |
| q | With intake manifold flaps |
| q | Removing and installing → Chapter. |
| 7 - | Coupling rod |
| 8 - | Intake manifold flap motor -V157- and intake manifold flap potentiometer -G336- |
| q | Removing and installing → Chapter. |
| 9 - | 7 Nm |
| 10 - | To activated charcoal filter. |
| 11 - | Hose |
| 12 - | Activated charcoal filter solenoid valve 1 -N80- |
| 13 - | Hose |
| 14 - | Dual non-return valve |
| q | Check → Chapter. |
| 15 - | Intake manifold support |
| 16 - | 25 Nm |
| 17 - | 10 Nm |
| 18 - | Bonded rubber mounting |
| 19 - | Throttle valve module -J338- |
| q | Including throttle valve drive (electric throttle operation) -G186-, angle sender 1 for throttle valve drive (electric throttle operation) -G187- and angle sender 2 for throttle valve drive (electric throttle operation) -G188-. |
| q | Removing and installing → Chapter. |
| 20 - | 7 Nm |
| 21 - | Seal |
| q | Renew if damaged. |
| 22 - | 5 Nm |
| 23 - | Intake air temperature sender -G42- |
| 24 - | 10 Nm |
