volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing camshaft > < Removing

Golf Mk6

Installing
Installing
l  The pistons must not be positioned at TDC.
   
–  Slide oil seal over guide sleeve -T10071/1-.
–  Remove guide sleeve.
  A15-0924
–  Press oil seal in onto stop with fitting sleeve -3265- and bolt -T10071/2-.
  Note
Put a large, commercially available washer M12 under bolt to avoid wear to fitting sleeve.
–  Insert parallel key into camshaft.
  N15-0641
–  Install camshaft toothed belt pulley. When tightening camshaft toothed belt pulley bolt, hold with counterhold -3415-. Torque setting: 100 Nm.
  Note
When camshaft is turned, crankshaft must not be at TDC. Danger of damage to valves and piston crowns.
Further assembly is basically the reverse of the dismantling procedure.
Installing toothed belt → Chapter.
  N15-0455

Removing and installing camshaft > < Removing