Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing fuel system diagnostic pumpV144 (Golf) >
< Assembly overview - activated charcoal filter system (Golf)
Golf Mk6
Power unit
4-cylinder injection engine (1.8 and 2.0 l engine, chain drive)
Fuel supply, gas operation
Activated charcoal filter system (Golf, Eos with engine code CBFA, CCTA, CCTB)
Removing and installing activated charcoal filter
Removing and installing activated charcoal filter
Removing and installing activated charcoal filter
Special tools and workshop equipment required
t
Engine and gearbox jack -V.A.G 1383 A-
Removing:
–
Remove centre and rear silencers.
–
Remove heat shield
-arrows-
.
–
Position engine and gearbox jack -V.A.G 1383 A- below rear axle to support.
–
Loosen securing bolts of rear axle
-arrows-
and unscrew approx. 20 mm.
–
Lower rear axle slowly using engine and gearbox jack -V.A.G 1383 A-.
–
Pull off breather lines
-A-
by pressing release tab.
–
Unscrew bolts
-B-
.
Note
A reinforcement plate is installed in the Eos. To loosen and tighten securing bolts
-B-
, use T-bar and socket 10 mm -3185-.
–
Release retaining tabs
-A-
using a screwdriver. Turn activated charcoal filter approx. 90° to right
-B-
and remove activated charcoal filter.
Installing:
Installation is carried out in the reverse order. When installing, note the following:
–
Fit breather lines so that they engage audibly.
–
Install rear axle
→ Running gear; Rep. gr.42
.
Specified torque
Component
Nm
Activated charcoal filter to body
8
Power unit
4-cylinder injection engine (1.8 and 2.0 l engine, chain drive)
Fuel supply, gas operation
Activated charcoal filter system (Golf, Eos with engine code CBFA, CCTA, CCTB)
Removing and installing activated charcoal filter
Removing and installing fuel system diagnostic pumpV144 (Golf) >
< Assembly overview - activated charcoal filter system (Golf)