volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing tail light (tail light cluster) bulb carrier in rear lid > < Assembly overview - tail light (tail light cluster) in rear lid

Golf Mk6

Removing and installing tail light (tail light cluster) in rear lid
Removing and installing tail light (tail light cluster) in rear lid
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
   
–  Unclip service flap -1- in direction of -arrow- out of trim.
  N94-11531
–  Release and disconnect connector -1-.
  N94-11532
–  Remove securing nuts -1-.
  N94-11533
–  Swing tail light -1- in direction of -arrow- out of body aperture in rear lid.
Installing:
Installation is carried out in the reverse order. When installing observe the following:
  N94-11534
–  Swing tail light -1- in direction of -arrow- into body aperture in rear lid.
–  Tighten securing nuts to torque specified in assembly overview → Chapter.
–  Reconnect connector until it engages audibly.
–  When installation is complete, check functions of tail light and gap/shut lines to body.
  N94-11535

Removing and installing tail light (tail light cluster) bulb carrier in rear lid > < Assembly overview - tail light (tail light cluster) in rear lid