Golf GL L4-2.0L (AZG) (2001)
-
Connect VAS 5051 to data link connector in vehicle using "special" VAS 6103 cable
-
Press "Continue" button
-
Turn ignition ON
-
Press "Continue" button and wait for "Programming progress" screen
-
Example of "Programming progress" screen
-
After program has run completely, this message appears at the bottom of the screen, in a green box.
NOTE: VAS 5051 will automatically reboot to the Start-up screen.
-
If ECM does not need reprogramming, this message will appear at the bottom of the screen, in a blue box. No further work is required.
NOTE: VAS 5051 will automatically reboot to the Start-up screen.
-
If this message appears in a red box at the bottom of the screen, reprogramming is not necessary.
NOTE: VAS 5051 will automatically reboot to the Start-up screen.
-
Turn ignition switch to "OFF" position and disconnect VAS 6103 cable from vehicle
-
Proceed to SECTION D