Golf GL L4-2.0L (AZG) (2001)
Connecting For Wiring Test
Vehicles with engine code AEG
-
Check wires between test box and 4-pin connector (to control module) for open circuit according to wiring diagram.
Terminal 3 + socket 51
Terminal 4 + socket 52
Wire resistance: max: 1.5 Ohms
Vehicles with engine code AVH, AZG
-
Check wires between test box and 4-pin connector (to control module) for open circuit according to wiring diagram.
Terminal 3 + socket 68
Terminal 4 + socket 69
Wire resistance: max: 1.5 Ohms
Continuation for all vehicles
-
Also check wires for short circuit to B+ and Ground (GND). Specified value: Infinite Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
With Manufacturer's Scan Tool
Oxygen Sensor and Oxygen Sensor Control After Catalyst, Checking
NOTE:
-
Raise vehicle to reach Oxygen sensor connector.
-
Only gold contacts may be used for servicing contacts 3 and 4 in connector for Oxygen sensor.
Special tools and equipment
-
V.A.G 1551 scan tool or or 1552 scan tool with cable VAG 1551/3
-
Test box VAG 1598/31
-
Hand multimeter VAG 1526 or multimeter VAG 1715
-
Adapter set VAG 1594
-
Wiring diagram
Check conditions