Jetta L4-1.9L DSL Turbo (BEW) (2004)
/Page-2165002.png)
-
Push cutting cord through adhesive sealant into vehicle interior using awl (from V.A.G1474).
-
Using small tube - 1 -, guide in cutting cord between seal and window flange.
-
Pull through outer cord end inward and counterhold using Pulling grip V.A.G 1351/1.
-
Secure one cord end to Spooling tool V.A.G1654A and cut window free by positioning spooling tool.
-
While cutting free, press cutting cord against window using plastic wedge in order to have clearance from window flange.
-
In area of C-pillar, two securing pins are installed on window. Securing pins are cut through when cutting through adhesive bead.
Window is re-installed without securing pins since they are not available as replacement parts.
-
As shown in illustration, one suction cup can be removed from spooling tool. By doing this, roller of spooling tool can be placed closer to window
flange.
Damaged Side Window, Removing
