Jetta L4-2.0L (AZG) (2004)
-
Note position of printed circuits and wiring -item 5-
-
When installing do not damage contact springs -item 27- for selector lever position display
8. Bolt, 7 Nm
-
For locating spring -item- 12 and plate -item 11- to frame
9. Shim
10. Locking segment
-
Place on centralizing elements of selector lever housing -item 16-
11. Plate
12. Locating spring with roller
-
Locates in the detent in selector lever -item 13-
13. Selector lever
-
With pull rod, spring, detent, contact spring for selector lever position and releasing locking cable
14. Roller
15. Circlip
16. Selector lever housing
-
Need not be removed to replace the majority of individual parts, with the exception of selector lever and selector lever lock solenoid
17. Fulcrum pin
-
Splined
-
Grease shank
-
Do not turn when installing selector lever
18. Bolt, 25 Nm
19. Locking lever
-
For locking cable
-
For locking in selector lever position p
20. Shim
21. Bolt
22. Gasket
-
Always replace
23. Cover
-
For selector lever housing
24. Bolt
-
Qty. 14
25. O-ring
-
Always replace
26. Bolt, 8 Nm
-
Qty. 2
27. Contact spring
-
For selector lever position display
28. Bolt, 4 Nm
-
Place selector lever in to loosen and tighten
29. Clip
30. Steering lock
31. Bolt
-
Qty. 2
-
Solenoid to selector lever housing
32. Shift lock solenoid -N110-
-
Removing and installing
-
Can be checked in electrical test and in measured value block
-
Only remove and install with selector lever in position "1"
-
Note positions of spring and locking pin when removing
-
Remove together with locking pin and spring, and when doing this move selector lever back and forth slightly
-
Route wiring with sufficient clearance to selector lever
33. Cable tie
-
Wiring/solenoid to selector lever housing
-
Always replace
34. Spring
35. Locking pin
36. Nut, 13 Nm
-
Always replace
37. Washer
38. Nut, 25 Nm
-
Qty. 2
-
Always replace
39. Locking cable
-
For ignition key removal lock
-
Must not be kinked