Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
/Page-1751003.png)
31 - Bolt
^
Qty. 2
^
Solenoid to selector lever housing
32 - Shift lock solenoid -N110-
^
Only remove and install with selector lever in position "1"
^
Pay attention to spring and locking pin when removing
^
Remove together with locking pin and spring. When doing this move selector lever back and forth slightly
^
Route wiring with sufficient clearance to selector lever
33 - Cable tie
^
Wiring/solenoid to selector lever housing
^
Always replace
34 - Spring
35 - Locking pin
36 - Nut
^
13 Nm
^
Always replace
37 - Washer
38 - Nut
^
25 Nm
^
Qty. 2
39 - Locking cable
^
For ignition key removal lock
^
Must not be kinked
^
Checking operation of the ignition key withdrawal lock.
40 - Circlip
^
Always replace
^
For mounting selector lever cable to selector lever housing
^
Install with angled end inside selector housing
41 - Gasket
^
Always replace
42 - Selector lever cable
^
Do not bend or kink
^
If the outer cable is damaged the selector lever cable must be replaced
^
Lightly grease ball socket and cable ends before installing
43 - Lever
^
For selector shaft
44 - Support bracket
^
For mounting selector lever cable on transmission
45 - Circlip
^
Always replace
