Jetta Sedan L5-2.5L (CBTA) (2009)
Wiring Harness with 8-Pin Connector
25
Seal
‹› Always replace
26
ATF drain plug
‹› Tightening specification: --> [ Tightening Specifications ] See: Specifications/Mechanical Specifications/09G Transmission (6 Speed
A/T)/Tightening Specifications.
27
Selector lever
‹› For selector shaft
‹› Removing and installing --> [ Valve Body ] See: Service and Repair
28
Washer
29
Nut
‹› Note nut installation position.
‹› Tightening specification: --> [ Tightening Specifications ] See: Specifications/Mechanical Specifications/09G Transmission (6 Speed
A/T)/Tightening Specifications.
30
Large spring
‹› Not installed in all transmissions
31
Small spring
32
Damper piston
33
Wiring harness with 14-pin connector
‹› With O-ring on connector; always replace O-ring
‹› For solenoid valves
‹› Solenoid valve locations and wiring harness routing.
‹› Removing and installing --> [ Valve Body Wiring Harness with 14-Pin Connector ] See: Wiring Harness/Service and Repair/Valve Body
Wiring Harness with 14-Pin Connector
34
Bolt
‹› Tightening specification: --> [ Tightening Specifications ] See: Specifications/Mechanical Specifications/09G Transmission (6 Speed
A/T)/Tightening Specifications.