Jetta SportWagen L5-2.5L (CBUA) (2009)
Lower B-Pillar Trim
‹› Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the
same manner.
Removing
-
In vehicles with interior monitoring system, switch ignition off.
-
Remove sill panel trim. Refer to --> [ Sill Panel Trim ] See: Scuff Plate/Service and Repair.
-
Remove upper B-pillar trim. Refer to --> [ Upper B-Pillar Trim ].
-
Remove the two bolts - 1 - (4 Nm).
-
Remove trim - 3 - from door seal piping.
-
Remove trim in area of guide - 2 - from mounts in body.
-
In vehicles with interior monitoring system, disconnect wiring harness from sensor.
Installing
To install, perform the steps used for removal in reverse order.
C-Pillar Trim, Wagon
Pillar and Side Trim