volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting panel seal > < Installing

New Beetle

Adjusting height of sliding/tilting sunroof glass panel
Adjusting height of sliding/tilting sunroof glass panel
Sliding/tilting sunroof zero (0) position OK.
–  Tilt sunroof.
–  Slide sun blind to rear.
   
–  Unclip lower trim -2- in forward area, inwards to centre of vehicle and unhook at rear.
–  Unclip upper trim -1- at front and centre and unhook at rear.
–  Loosen securing bolts -3- (Torx key -T25-; 4.5 Nm).
–  Run glass panel into “closed” position.
–  Carry out height adjustment of glass panel at front and rear on both sides as follows:
  N60-0114
Panel adjustment front:
-a- = 0...1 mm lower than roof level
-Arrow- = Forwards
  N60-0098
Panel adjustment rear:
-b- = 0...1 mm higher than roof level
-Arrow- = Forwards
–  Tighten screws for glass panel (4.5 Nm).
Always tighten left and right sides of glass panel symmetrically.
–  Tilt sunroof.
  N60-0099
–  Hook in upper trim -1- at rear and clip front and centre in.
–  Hook in rear of lower trim -2- and clip front in.
  N60-0107

Adjusting panel seal > < Installing