New Beetle L4-2.0L (AVH) (2005)
-
Check resistance for sensor heater at connector to oxygen sensor terminal 3+4.
Specified value: 2.5 to 10.0 Ohms (at room temperature)
If specified value is not obtained:
-
Replace Heated Oxygen Sensor (HO2S) -G39-.
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check Ground (GND) activation of oxygen sensor heater.
-
Connect test box to control module wiring harness. connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
-
Check wires between test box and 6-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 4 + socket 5
Wire resistance: max. 1.5 Ohms
-
Check wires for short circuit to B+ and to Ground (GND).
Specified value: Infinite Ohms
-
Check wire between 6-pin connector terminal 3 and Fuel Pump (FP) relay -J17- for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.