New Beetle L5-2.5L (BPS) (2006)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Seal, Transmission Side
Crankshaft Seal, Transmission Side
Special tools, testers and auxiliary items required
‹› Assembly tool (T10122)
‹› Pulling hook (T20143)
Removing
-
Remove the transmission.
-
Lock the crankshaft. Refer to => [ Crankshaft, Locking ] See: Cylinder Block Assembly/Crankshaft/Service and Repair/Procedures/Crankshaft,
Locking.
-
Remove the flywheel or drive plate and remove the sensor wheel for the engine speed (RPM) sensor (G28) from the crankshaft.
-
Pull out the seal using (T20143/2).
Do not damage the crankshaft sealing surface when doing this.
Installing
‹› Do not additionally oil or grease the sealing lip of the oil seal!
-
Clean the sealing surfaces. They must be free of oil and grease.
-
Before installing, remove any remaining oil from the end of the crankshaft with a clean cloth.
-
Insert the (T10122/1) onto the (T10122/2 ) and slide the seal - A - onto the (T10122/2 ).