Volkswagen Workshop Service and Repair Manuals

• Gear stick knob
• Gaiter collar
• Retaining collar
• Spring collar
• ◆ Removing => Fig.1
• ◆ Installing => Fig. 2
• Cover
• ◆ Pull off from frame
• ◆ Connect to gear stick knob before installing
• Rubber cover with frame
• ◆ Always remove and install together
• ◆ After installing fit gaiter (Item 5 )

• Plastic nut
• ◆ Console to gear stick housing
• ◆ Remove before removing gear selector mechanism
• Spacer sleeve
• ◆ Between console and gear stick housing
• Gasket
• ◆ Between gear stick housing and floor
• ◆ Self-adhesive
• ◆ Bond to gear stick housing
• Hexagon bolt, 15 Nm
• ◆ For mounting plate to gear stick housing
• Gear stick housing

• Gasket
• ◆ Self-adhesive
• ◆ Bond underneath gear stick housing
• Gasket
• ◆ Between selector cables and gear stick housing
• Central console

→ Fig.1     Removing gear stick gaiter

• ‒ Turn cover inside out.
• ‒ Lever off spring collar with a screwdriver.
• ‒ Take retaining collar off.

→ Fig.2     Installing gear stick gaiter

• ‒ Turn cover inside out.
• ‒ Insert gaiter collar -A- and clamp gaiter with retaining collar -B-.

Installation position: Retaining collar shoulder towards spring collar.

• ‒ Fit gear stick knob and clip spring collar -C- into gear stick knob inner groove.
• ‒ Install gaiter over rubber cover to frame.