Volkswagen Workshop Service and Repair Manuals

Vehicles with manual gearbox

Engine code AAM, ABS, ADZ

• ‒ → Adjust throttle cable by moving the retainer at the support bracket so that the full throttle position is attained at the throttle valve lever.

Engine code 2E, ADY, AGG

• ‒ → Adjust throttle cable by moving the retainer at the support bracket so that the full throttle position is attained at the throttle valve lever.

Vehicles with automatic gearbox

• ‒ → Clamp distance piece -1-,
       a = 15 mm,
  between accelerator pedal -2- and stop -3- and hold accelerator pedal in this position.

Engine code AAM, ABS, ADZ

• ‒ → Adjust throttle cable by moving the retainer at the support bracket so that the full throttle position is attained at the throttle valve lever.

Engine code 2E, ADY, AGG

• ‒ → Adjust throttle cable by moving the retainer at the support bracket so that the full throttle position is attained at the throttle valve lever.

Continued for all engine codes

• ‒ Release accelerator pedal.

• ‒ → Connect hand multimeter V.A.G 1526 with aux. cables from V.A.G 1594 to kickdown switch.
• ‒ Check resistance at switch.
       Specification: ∞ω
• ‒ Slowly move accelerator pedal in direction of full throttle.

Shortly after the kickdown pressure point the resistance must drop to 0 ω.
At this point the accelerator pedal must be just off the stop.