| –
| Dissipate vacuum in brake servo by depressing brake pedal several times. |
| –
| Remove intake plenum from mixture formation and throttle valve part with air hose. |
| –
| Pull vacuum line out of brake servo. |
| –
| Draw off as much brake fluid as possible from brake fluid reservoir using a suction bottle. |
| –
| Disconnect hydraulic unit supply pipes and clutch master cylinder from reservoir. |
| –
| Disconnect brake lines from tandem brake master cylinder. |
| –
| Unbolt tandem brake master cylinder from brake servo. |
| –
| Remove brake pedal position sender → Chapter. |
| –
| Remove right storage compartment below dash panel. |
| –
| Disconnect brake servo clevis from brake pedal. |
| –
| Unbolt brake servo from bulkhead. |
| –
| Removing clutch master cylinder. |
Note | Brake servo can only be removed once clutch master cylinder, tandem brake master cylinder and brake pedal position sender have been removed. |
|
|
|
