Passat Sedan L4-2.0L Turbo (BPY) (2007)
/Page-2222006.png)
‹› Do not damage the seal running surface on the input shaft.
Installing
-
Fill the space between the sealing lip and dust lip - arrow - halfway with sealing grease (G 052 128 A1).
-
Lightly lubricate the outer circumference of the seal with gear oil.
-
Drive in the seal using the (T40008) until it is flush.
-
Install the slave cylinder with release bearing. Refer to => [ Slave Cylinder with Release Bearing ] See: Clutch/Clutch Release Bearing/Service
