Passat Sedan V6-3.6L (BLV) (2008)
plugs.
-
Disconnect the brake lines - 1 - at the brake master cylinder and seal the lines with sealing plugs from repair kit part number. 1H0 698 311 A.
-
Remove the nuts - 2 - from brake master cylinder.
-
If present, remove heat shield.
-
Carefully take brake master cylinder out of brake booster.
-
Remove the brake lamp switch from brake master cylinder.
Installing
-
Installation is in reverse order of removal.
Observe the following points when installing:
-
When installing together the brake master cylinder and brake booster, make sure that the push rod is correctly located in the brake master cylinder.
-
Bleed brake system. Refer to => [ Brake System, Bleeding ] See: Brake Bleeding/Service and Repair/Brake System, Bleeding.