Passat Sedan V6-3.6L (BLV) (2008)
If the specified values were Not obtained:
-
Replace the Ambient Air Temperature Sensor (G17). Refer to the Repair Information.
If the specified values are obtained, continue the test according to the following table:
Checking wiring
-
Turn the ignition switch ON.
-
Connect a multimeter to terminals 1 and 2 of the Ambient Air Temperature Sensor (G17) electrical harness connector.
Specified value: near 5.02 V
-
Turn the ignition switch OFF.
If the specified value was Not obtained:
-
Remove the Instrument Cluster. Refer to the Repair Information.
-
Disconnect the Instrument Cluster harness.
-
Using a multimeter, check the Ambient Air Temperature Sensor (G17) electrical harness connector to the Instrument Cluster electrical harness T32
connector for an open circuit or a short, refer to the wiring diagram.
Specified value: 1.5 ohms max.
If the specified value was Not obtained:
-
Check the wiring for an open, high resistance or short circuit to voltage or ground.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Replace the Instrument Cluster. Refer to the Repair Information.